top of page

General Discussion

Público·1 miembro

Finally a fix for Samsungs giga notorious please wait issue.

Tired of Bluetooth issues, like the please wait issue or a stubborn disc drive, with your Samsung Giga sound system?


We finally have a repair kit to solve this issue.


This comprehensive 3-piece kit includes:


* 2 Pre-programmed Chips: Designed to address core system errors.


* 1 RAM Chip: To restore optimal performance and stability.


Clear instructions and the locations of the components


62 vistas

problem with 55" insignia tv

good day ok i have this issue with my tv ..after about 20 minutes of playing the screen flickers then red vertical lines flash on the screen and after a while the screen goes black but continues to talk..if i power the tv off then on it will come on back but after a while it will repeat the same process,,did some research was told most likely the tcon board .. so i went ahead and change the tcon board i also change the power board but the problem is still the exact same ..anyone can give any insight what might be the problem,, do you think it might be the main board or the cables,, i kinda rule out backlight as it comes on bk same time after power off and on,,i dont kno anyway so any input would be appreciated..



296 vistas
deetucks
Jan 23, 2025

not seeing a video,,,i did clean both long and short cables,,

Original Nintendo Nes No Video

Here is a beautiful Nintendo with no video, our culprit... "Capacitors". Of course most people tend to just replace the 72 pin set but that won't always fix th issue. There are 3 capacitors on the board that must be replaced if you have already tested and made sure your pin set is good. Please check the pictures below as it will better explain where the caps are located and what the values are. Hope this helps!


171 vistas

ChiliSleep unit with no power

This unit had showed no signs of life other then a faint clicking when plugged in. Once the unit was opened we noticed that the power supply had a burn mark right by the 12v transformer. We decided to replace the board instead of rebuilding the old one. This unit required a 12v 10amp power supply. Once installed, the unit powered up and began to work just fine.



206 vistas
bottom of page